- How to replace a dishwasher without garbage disposal how to#
- How to replace a dishwasher without garbage disposal install#
Finally, hold all these items in place while inserting the snap ring.ģ. Then from below, insert the gasket over the flange, the second flange if one was provided, and then the mounting ring.
How to replace a dishwasher without garbage disposal install#
To install the new mounting assembly, apply a generous ring of plumber’s putty around the flange and, from the top, press it into place in the sink’s drain hole. Next, from above, pry the flange from the sink’s hole and remove any existing plumber’s putty, old gaskets, or debris to create a clean surface for the new application.Ģ. Pull it down, along with any gaskets or backup rings. Then use a screwdriver to loosen and remove the screws holding everything to the sink flange. Begin by using a screwdriver to pry off the snap ring holding the old mounting assembly under the sink. No worries, it’s just an extra step, but just as straightforward.ġ. If your new garbage disposal doesn’t fit on the existing mounting assembly, you’ll need to remove it and replace it with the one supplied with the new unit. Then, fill the sink with water and look for leaks. Also, if needed, attach the dishwasher drain to its inlet tube.
Reattach the drain trap to the discharge tube. Then, turn the mounting tabs until the disposal locks into place. Next, turn it so that the tabs ride up those ramps to hold it in place. Step 5Īttach the disposal to the mounting assembly by lifting it while aligning the mounting tabs with the slide ramps. Step 4Īttach the discharge pipe to the disposal using the clamp provided. If your old unit was hardwired, but your new disposal came without an electrical cord, you can purchase and attach a cord kit. If your unit is hardwired, simply plug it into the outlet under your sink. Push the wires back into the disposal and replace the cover plate. Then connect the green wire to the grounding screw on the disposal. Connect white to white and black to black or red using wire nuts. If not hardwired, remove the electrical cover plate, pull out the wires, and connect the disposal to the power supply. If attaching a dishwasher, use a screwdriver to knock out the plug in the dishwasher inlet tube. If not, remove the old mounting assembly from your sink and install the new one by following the instructions below. First, determine if the disposal will fit on the old mounting assembly.
Most manufacturers ship everything assembled, making it necessary for you to disassemble the parts before installing them. Once you’ve removed the old disposal, remove the mounting assembly from the new disposal.
How to replace a dishwasher without garbage disposal how to#
How to install a new garbage disposal Step 1 If your disposal is wired directly, remove the cover plate and disconnect the wires.
Step 3įollow these steps to release the disposal from the mounting ring found towards the top of the unit. Also, disconnect the tubing from the dishwasher inlet. Disconnect the drain trap from the discharge tube. Place a small basin underneath the work area to catch water when disconnecting pipes. If your unit is hardwired, simply unplug it from the wall. Turn off the power to the disposal at the breaker box.
0 kommentar(er)
